It is time for tube rolling dear fellows! When the audio chain setup is complete and the key components have been chosen one should concentrate on the fine details. They are usually not bringing stunning but rather subtle improvements. My audio system recently reached such a state when all its key components were on place and I decided to finally tune it. Since the amplifier is the second most important component after the speakers that it drives it is vital to take the most out of it.
Continue reading “Rolling tubes”
For those who don’t know what notch filter is I’ll explain in short: the task of a notch filter is to reduce the strength of the audio signal in certain frequency range. Such a filter is usually used in a single driver (also known as broadband or full-range) speaker designs. Because it has only one driver it is often very hard or impossible for such a speaker to convey a flat response along the whole length of the frequency spectrum. Usually such a speakers emphasize certain frequencies that leads to tonal colourations.
Continue reading “Notch filter experiment”
It is strange how often it happens to me to change something in the audio system while experimenting and to notice an improvement. I enjoy the achieved result for some time but then I decide to restore the system to its initial state, only to realise that the so called “improvement” is nothing else but an effect that actually departs the reproduction from its authentic character.
Continue reading “Back at the beginning”
Speakers are the most important component in an audio chain. I can’t remember any other component that has influenced my home audio system as much as speakers did. Speakers disperse the sound waves inside the room interacting with its boundaries and one shouldn’t think about them separately but in conjunction with the particular room.
Continue reading “Speakers”